|
#1
|
||||
|
||||
Need Advice and Part #'s
I want to change cams in my 360.I was going to put a Comp XE 268 in it a few months ago but didn't.This is my engine specs.'86 360 bored .060,stock iron heads with the chambers hogged out,202 &160 valves, adjustable rockers,Edelbrock performer intake,600 Eddy carb,Howard's 212/216-447/447 112 centerline cam.I also have flat top hyper-u pistons.This is in my 87 Ram 2wd truck with a 727,stock converter and 3.55 gears.I want to keep my stock converter but would like it to have a nice choppy idle.If you guys have or know of a good cam to fit the bill ,let me know.
Eggman |
#2
|
||||
|
||||
advise
this is what i do before i really do anything, i use my desk top dyno to help me blue print my engines, its not totally acurate but it gives me an idea on what the engine is going to put out and what rpm my engine is going to not put out power anymore. There is a lot of tools needed if you want to degree your cam right, so just get a nice fat one like .302 duration .502 lift something like that and have fun. not much advise but and idea!
Se7eN |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
K&N part # ? | atvr | Ram Truck Chat | 5 | 04-26-2004 03:38 PM |
Need a part | steves86TA | Vintage MOPAR chat | 4 | 11-13-2003 09:17 PM |
K&N part # | Freemans30th | Ram Truck Chat | 0 | 03-03-2003 06:38 PM |
K&N part #s | openclasspro | Ram Truck Chat | 4 | 08-27-2001 05:46 PM |
Part # is the same, but is it the same R/T cam? | SUN RA KAT | Ram Truck Chat | 1 | 08-07-2000 05:32 AM |