|
#1
|
|||
|
|||
need a stroker kit
where can i get a stroker kit for a 1972 360.at a decent price!
|
#2
|
|||
|
|||
Ohiocrank.com around $950 gets you a cast 4" cranks,KB pistons,h-beam rods,rods and main bearings.to have it balance another $150.The cast cranks are good,i used one in my engine with 13.1 comp 360 than ran 10.60.it shouldve ran low low 10s but it held up.i was going to use NOS but the way it look a valve hit the piston so the engine blew.nothing was left but the crank still came out ok after that mess.now using a callies cranks for a W8 motor.Thats crank cost $900! go to rotating assemblies on ohiocrank.com
|
#3
|
|||
|
|||
thanks!thay said the cast crank will take 450 hp.im going for 550.will the cast crank handle 550 hp
|
#4
|
|||
|
|||
I think the cast cranks will take almost anything but 550 HP should be no problems.go for it
|
#5
|
||||
|
||||
|
#6
|
||||
|
||||
Quote:
|
#7
|
|||
|
|||
I second the motion for forged pistons.
|
#8
|
|||
|
|||
Of course use forged pistons if you are going to use nitrous,BUT you can nitrous with any pistons just BE CAREFUL.A friend of mine has cast pistons in a 351 ford that runs 14.20 he sprays it in second gear and runs a 12.30 with a 125 shot hp.he has been doing this for 5 years now.I ran customs diamond piston in my motor set up to use 300 shot of nitrous so i was worried about pistons
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stroker | jtmoney | Dakota Truck Forum | 63 | 10-02-2002 07:00 AM |
318 stroker | TrxR | Performance Talk | 26 | 09-13-2002 12:01 AM |
360 Stroker | TrxR | Performance Talk | 9 | 08-06-2002 08:22 AM |
360 stroker | bobbyg | Performance Talk | 1 | 05-27-2001 08:56 AM |
Eagle 'RB' 4.15 Stroker Crank VS. MP 4.15 Stroker Crank VS. Welded Stock Steel | krownman | Performance Talk | 5 | 03-04-2001 11:47 PM |