|
#1
|
||||
|
||||
Piston to valve clearance
Hi Guys, here I am again.... After tha last broked engine....
How can I measure te correct place and deep to make valve pockets onm my pistons ???? I saw at a book that the exaust valve is closest to the piston about 10º BTDC and Intake about 10 ATDC.... Is this correct ??? may I mark and measure with this informaion ??? Best regards, Odilo |
#2
|
|||
|
|||
The closest point is usually between 10 btdc and 10 atdc, you should check it at each degree between those points with the cam timing in the position you intend to drive. This is actually only needed with extermely tight valve to piston clearances.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Piston to valve clearance | Dukes2fast | Performance Talk | 1 | 07-04-2006 09:51 AM |
valve piston clearance | toad490 | Performance Talk | 3 | 06-01-2004 04:45 PM |
Valve to piston clearance | Mr.Mopar | Performance Talk | 3 | 04-14-2002 08:25 PM |
Piston to Valve Clearance | Pro 440 GTX | Performance Talk | 1 | 02-20-2002 07:57 PM |
Valve Lash Adj & Piston to Valve Clearance | WS23 | Performance Talk | 3 | 09-26-2001 01:00 PM |