|
#1
|
||||
|
||||
sub wiring for maximum sound
i have to kicker 12s in a sealed box. 600 watt amp. the amp is bridged, and one ohm stable. how do i wire the subs up to drop the resistyance load to 2 ohms? thanks
mike |
#2
|
|||
|
|||
positive to positive neg to neg,,,then pos to pos on amp then neg to neg on amp,,,,,,
what kinda amp,,,some amps say they are 2 ohm stable but realy arnt ,,,realy only top quality amps should be run at two ohms,,,or it will be short term
|
#3
|
||||
|
||||
its in a buddies car. its a boss audio. i was assuming since they claimed it was one ohm stable, itd be safe for two. what do you say?
mike |
#4
|
|||
|
|||
shortlived
it would probobly work,,but would be short lived,,,and suck alot of amperage
|
#5
|
|||
|
|||
U are mixing 2 issues.
Issue 1 How do U wire the subs up for a 2 ohm load? Assuming the subs are 4 ohm, wire the plus terminal of sub 1 to the plus of sub 2. Next wire the minus terminal of sub 1 to the minus of sub 2, then take 1 wire from the sub's plus and connect to the amp (+terminal) then do the same for sub's minus terminal and connect to the amp (- terminal). Issue 2 The boss amp may not have enough power @ 2 ohms but try it, typically the lower cost amps have little current and are not satisfactory for subs. To connect U want it to be in a bridged (mono) mode check the info carefully either the manual or markings on the speaker terminals. If after getting everything running check the amp's temperature, if really hot U better turn it down or consider upgrading the amp..... |
#6
|
||||
|
||||
thanks guys. thats what i needed to know. and ill make sure not to fry his amp.
mike |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Low maximum RPM 95 5.9L Diesel | Grayhawk | Diesel & Turbo Diesel Chat | 2 | 11-16-2008 10:15 AM |
Maximum Boring for a 413 | Jack_440 Savoy | Performance Talk | 11 | 10-15-2007 03:21 AM |
Maximum Hp With Manifolds… | RR3834bbl | Performance Talk | 5 | 11-27-2006 07:15 AM |
Maximum Taper on a 440... | The Dartman | Performance Talk | 11 | 12-12-2004 12:30 AM |
maximum hp/torque from a 318??? | RH41J | Performance Talk | 1 | 07-10-2001 07:56 AM |