|
#1
|
|||
|
|||
Ring Gap
What should ring gap be for second ring on KB pistons? 360 Magnum, daily driver.
|
#2
|
||||
|
||||
from KB piston sheet
According to the sheets supplied with my KB pistons for a normally aspirated gas engine: Ring End Gap Factor is .0065
Cylinder bore X .0065 4.00 X .0065 = .026" 4.030 X .0065 = .026" Note the second ring gaps do not need to extra clearance. same as first ring .026 I installed chrome rings in my engine and decided to use the ring manufacturers specs. .018" to .020" that was my choice and I haven't had problems with them yet. (two years) Jimm II |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3.23 ring and pinion | Zorb | Rear Wheel Drive - Parts Wanted | 4 | 07-03-2008 01:23 AM |
Looking for a gas cap trim ring for a 67 GTX | giggity75 | Rear Wheel Drive - Parts Wanted | 1 | 04-15-2008 08:55 PM |
273 ring gap | FG | Vintage MOPAR chat | 4 | 01-25-2003 09:26 PM |
Ring Gap | 65 racer | Drag Racing Forum | 1 | 03-10-2002 06:02 PM |
Ring end gap?? | mopardude | Performance Talk | 2 | 03-19-2000 05:59 PM |