|
#1
|
|||
|
|||
A little help needed
Been so long out of the grove I had to rejoin and of course my email had changed
Looking to add a 8-71 to a 440 but my engine sits under firewall a bit. Anyone have one that could take a few mesurments ? Really needing back side of blower to bell housing mesurment and any more you think I could use In this picture you can see what im up aginst Sorry tried to post large picture but it would not let me Thanks for your help, William |
#2
|
|||
|
|||
We have one with the BDS intake, if I remeber I can measure it tonight.
http://www.youtube.com/watch?v=IVeBxNEFEN4 |
#3
|
|||
|
|||
Only 1 blown big block owner here ?
|
#4
|
|||
|
|||
Remembered to check that last night, it's about 1.5" from the bellhousing flnage to the rear of hte 8-71.
|
#5
|
|||
|
|||
I have see a set up from Dyers and if you have any manifold clearance vertically on your current set up you will make it. Blower manufacturers will be able to guide you. However, if the motor is pitched back at all that will obviously effect your vertical clearance...but that's what hammers are for
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
M1 Needed | OmniDak | Trucks - Parts Wanted | 2 | 02-27-2006 11:59 AM |
pvc? needed? | coolcarz | Performance Talk | 8 | 03-10-2004 06:33 PM |
More help needed | greatone | Ram Truck Chat | 0 | 10-23-2002 07:50 PM |
Transmission guys-quick answer needed-rebuild needed? | SS/Teve | Ram Truck Chat | 10 | 03-08-2002 07:05 PM |
I just needed to use your car | Stoga | Joke Forum | 0 | 11-03-2001 11:41 PM |