Imca hobby stock
Putting a new bullet together for the hobby stock. 340 block, 4.06 bore 3.31 stroke. 284/288 cam. 244/250 @.050 .560 intake lift with crane 1.6 rockers. I'll post pictures if someone can tell me how.
|
340 Build
What heads and compression are you running? It’s all about compression and head flow.
Photos are attached using the attachment dialogue box down below. Click on the add attachment box. You will get options to attach files. The trick is making the files smaller. I used Gimp a freeware photo editor. You can resize the files with that until the program accepts them. |
3 Attachment(s)
Imca 9.0-1
|
cam
What heads are you running and what brand is the cam thanks
|
Heads are over the counter 576 castings. Basically a 308 head.
Schneider cam |
3
Thanks Dodge man I take in as much info as I can get where are you racing
|
Wisconsin. We did pull down to the Lonestar 600 in 21
|
I had RET RACING ENGINE TECHNOLOGIES in Michigan work on my heads. A very conservative understand cover port work.
|
chas
Nice to have so many options Machine work and tracks are a bit limited up here but competition is not
What chassy are you running I could not keep the ft. end under the duster or dart when it held up we won when it didn't it was a real hand full going to give in and put the body on a metric |
5 Attachment(s)
It's a transverse torsion bar 78 Aspen.Attachment 16191
Attachment 16192 Attachment 16193 Attachment 16194 Attachment 16195 |
I'VE reinforced the upper control arm and shock mounts. the k frame is welded to the frame rails. We run a passenger side upper control arm on the drivers side. it moves the ball joint forward for caster stagger.
|
a arm
Love the reverse a arm good thinking
go gettem |
All times are GMT -4. The time now is 07:47 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.