Thankyou for that info, it proved very helpful.
Yes I do already have the drive system.
I have taken your advise & used a manifold I already had -
Its an edelbrock quad duel plane manifold.
I got the top milled, Got a aluminium adaptor plate made (Not cheap
& bolted it to the manifold with high tensile bolts (I did not mill the manifold too much as I didnt want the blower to sit too low -May as well flant it eh?)
Got the pressure relief valve added to the location you suggested.
The manifold had spread bore inlets(4 intake holes for each 4bl carb) as it is a duel plane, Do you think I should cut them out or leave them as is?
Or do you think that the manifold that I have used will be unsutible for a blower?
Thanks mate
|