97 Ram front U-Joint replacement
I have a 97 Ram 1500 4 X 4 in need of front U-Joint replacement.
My question is. To pull the passenger side axle, do I have to remove the auto locker on the axle housing first or should the axle just slide out when the bearing assembly is loosened? |
On my 98 i had to remove the hub from the knuckle.Then the axle just slides out.Four bolts on back side thnk they are 15 mm.
|
I just replaced one on my 96 yesterday. Just take out your 3 hub bolts 15mm you may have to pry your hub loose but leave axle nut on and pull whole assembely off and your axle shaft will slide out with it . Quick and easy only about a 30 min. job hope this helps.
DON'T YOU JUST LOVE THE SMELL OFF BURNT RUBBER!!!!!!!!!!!! |
All times are GMT -4. The time now is 08:18 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.