|
|
|
|||||||
|
#1
08-10-2003, 04:47 PM
|
|||
|
|||
Good place to go through firewall?
Hey guys, I'm going to be putting on an electric cutout to open my exhaust a bit
 and I'm going to need to run the cable to the inside of the cab. I just need a good place to route it through. Any ideas?Thanks! Nathan 
|
|
#3
08-10-2003, 08:25 PM
|
||||
|
||||
|
Well on my 99 I poke a nail through this large rubber plug and then push my wire through. It seals right around it nice and tight and you can't even force another wire through unless you've poked it with the nail again. I've done thie many times since I have lots of extras installed.
|
|
#4
08-11-2003, 01:20 AM
|
||||
|
||||
|
whered u get ur cut outs from???
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Any good place to start in diagnosis?? | Sam Parkinson | Ram Truck Chat | 6 | 08-26-2018 09:54 PM |
| good place to tap in for temp gauge? | m4s | Vintage MOPAR chat | 6 | 01-04-2003 12:24 AM |
| Where is a good place to sell a Mopar? | 68Dodgecharger | Performance Talk | 4 | 06-24-2002 12:10 PM |
| looking for a good place to cruise | rainydazes | Street Warrior Forum - great street race stories..... | 0 | 06-08-2002 03:05 AM |
| Good place to tap ignition power? | AZRAM | Ram Truck Chat | 0 | 04-09-2001 02:56 PM |
Linear Mode
